Features:
Manual movement of the cutter motor unit across machine.
Cutter follows path of guide pin against a spacer bar, with choice of four different spacings and dovetail shapes.
Pneumatic clamping of two vertical and two horizontal workpieces.
Eccentric cutter collet and single flute cutter allows fine cutter adjustment to produce perfectly fitting dovetails.
Floor stand for machine included – rigid and strong.
Click here for Product Data Sheet on the 650.(PDF 116kb)

Features:
Cast iron machine with moving table and work clamp.
Drill bit held by 13mm drill chuck on motor shaft.
Square chisel held by clamping bolt in cast iron head.
Complete work head strokes up and down by hand lever.
Cast iron work table moves sideways by central lever, and adjusts in and out by knurled knob.
Screw type work clamp locks timber onto work table.
Depth stops can be pre-set on head rise & fall.
Click here for Product Data Sheet on the MS-3816.(PDF 110kb)

Features:
Cast iron machine on sheet steel cabinet stand.
Drill bit held by 16mm drill chuck on motor shaft.
Square chisel held by clamping bolt in cast iron head.
Complete work head strokes up and down by hand lever.
Cast iron work table moves sideways by central handwheel, and adjusts in and out by left handwheel.
Quick action work clamp locks timber onto work table.
Quick action top clamps hold timber down hard on table.
Length stops can be pre-set to right of work table.
Click here for Product Data Sheet on the MS-3840.(PDF 106kb)

Features:
Cast iron machine on sheet steel cabinet stand.
Drill bit held by 16mm drill chuck on motor shaft.
Square chisel held by clamping bolt in cast iron head.
Complete work head strokes up and down by hand lever with counter weight to assist lifting.
Convenient large handwheel for two operations –
1.       Lateral movement of work table to centre the mortise.
2.       Longitudinal movement of work table when mortising.
Cast iron work clamp locks timber onto work table.
A depth stop can be pre-set to correct mortise depth.
Magnetic switchgear with no-volt release & overload protection.
Click here for Product Data Sheet on the CT-1913.(PDF 110kb)

Features:
Industrial machine with capacity to mortise doors.
Cast iron machine on sheet steel cabinet stand.
Drill bit held by 16mm drill chuck on motor shaft.
Square chisel held by clamping bolt in cast iron head.
Complete work head strokes up and down by hand lever.
Hand lever movement forward & back of work head, to centre mortices in timber of various widths.
Hand lever longitudinal movement of work head to left and right, to set desired length of mortice.
Work table tiltable up to 90º, to mortise ends of timber to maximum 1 metre long.
Cast iron work clamp locks timber onto work table.
Mortise length stops can be pre-set to stop work table.
Magnetic switchgear with no-volt release & overload protection.
Click here for Product Data Sheet on the CT-2305.(PDF 110kb)

Features:
Vertical head movement on ground round slides with precision, self lubricating bronze bushes.
Vertical movement counterbalanced by two compression springs.
Horizontal head movement on ground, hardened round slides with precision, sealed self lubricating ball bush type linear bearings.
Mortising head can rotate 45° to right or left, with angle graduations to produce mortises angled as required.
Shavings exhaust connection provided at rear.
Lubricating pump provided to oil chains and guide bars.
Locking work stops provided to pre-set mortise size.
Required spanners provided to operate machine.
Bottom workpiece support to mortise doors etc.
Click here for Product Data Sheet on the GT40S.(PDF 112kb)